THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION

ZHAO Yan; YANG Zhiyi; YANG Wantai

doi:null

您当前的位置：

首页 >

文章列表页 >

THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION

Research Article | 更新时间：2021-03-19

- THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION
- Acta Polymerica Sinica Issue 5, Pages: 743-748(2004)
- 作者机构：
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：20 October 2004，
扫描看全文
ZHAO Yan, YANG Zhiyi, YANG Wantai. THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION. [J]. Acta Polymerica Sinica (5):743-748(2004)
DOI：

ZHAO Yan, YANG Zhiyi, YANG Wantai. THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION. [J]. Acta Polymerica Sinica (5):743-748(2004) DOI：

摘要

采用大分子单体法合成了一系列聚苯乙烯接枝壬基酚聚氧乙烯(PS-g-NPEO)两亲共聚物

采用溶液铸膜法将其在PET表面制膜

并利用扫描电子显微镜 (SEM)

X射线光电子能谱(XPS)

衰减全反射红外光谱(ATR)和水接触角 (CA)等手段研究了共聚物组成、铸膜溶剂及浓度对共聚物膜表面形貌、组成及水浸润性能的影响 .结果表明

两亲接枝共聚物在不同条件下可形成规则的表面微孔

共聚物中NPEO含量越高

共聚物膜表面微孔孔径越大

对应的水接触角越小.以THF为铸膜溶剂时

制膜浓度越大

共聚物膜表面微孔孔径越大

对应的水接触角越小;而以甲苯为溶剂时

制膜浓度对共聚物膜表面形貌影响不大

但水接触角要较THF体系显著降低

水接触角与浓度关系与THF体系相反

制膜浓度越大

对应的水接触角越大.制膜浓度相同时

THF作溶剂

共聚物膜微孔较大

表面亲水组分含量较低 ;以甲苯为溶剂

微孔较密

表面亲水组分较高.

Abstract

Amphiphilic graft copolymer polystyrene-graft-nonylphenoxy-poly(ethylene oxide) (PS-g-NPEO 40) has been synthesized by the radical solution copolymerization of macromonomer NPEO-MA with styrene．By the method of coating-evaporating

amphiphilic graft copolymer films were prepared with THF or toluene as solvents on PET matrix．By means of SEM

XPS

ATR and contact angle measurements

effects on the surface morphology

the surface composition and the surface wetting were investigated．The results showed the formation of regular micropores in amphiphilic graft copolymer films under different conditions. With the increasing of NPEO content

the size of micropores increased and the wetting of polymeric film became better．With the increasing of the solution concentration

the diameter of micropores increased

which makes the wetting of polymeric film better. While in toluene

the influence of the solution concentration on surface morphology was weak

but the relationship of contact angle and concentration was opposite to that in THF

i．e．

with the increasing of concentration

the wetting of amphiphilic graft copolymer film became worse. In the same solution concentration

the diameter of micropores of polymeric film in THF was bigger than that in toluene and the hydrophilic composition in THF was less than that in toluene.

关键词

PS-g-NPEO接枝共聚物表面形貌表面组成水接触角

Keywords

references

更多指标>

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

SYNTHESIS AND CHARACTERIZATION OF P(VDF-co-TrFE-co-CTFE)-g-SPS

SYNTHESIS AND CHARACTERIZATION OF ELECTROACTIVE GRAFT COPOLYMER OF POLY(L-GLUTAMIC ACID)-g-ANILINE TETRAMER

SYNTHESIS OF STYRYLCAPPED ISOTACTIC POLYPROPYLENES AND THEIR APPLICATION IN SYNTHESIS OF POLYPROPYLENES WITH TOPOLOGICAL STRUCTURE

STUDIES ON PARTICLE SIZE CONTROL OF GELATION MICROSPHERES

AMPHIPHILIC PPESK-g-PEG GRAFT COPOLYMERS SYNTHESIZED via WILLIAMSON METHOD

Related Author

No data

Related Institution

No data

Postal code：100190
Tel：010-62588927 Email：gfzxb@iccas.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备05002797号-8 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰