ETHYLENE POLYMERIZATION OVER MgCl2/AlEtn(OEt)3-n SUPPORTEDHALF-TITANOCENE CATALYSTS

LIU Dan; ZHU Fangming; LIN Shang’an

doi:10.3724/SP.J.1105.2008.01129

您当前的位置：

首页 >

文章列表页 >

ETHYLENE POLYMERIZATION OVER MgCl2/AlEtn(OEt)3-n SUPPORTEDHALF-TITANOCENE CATALYSTS

Research Article | 更新时间：2021-03-19

- ETHYLENE POLYMERIZATION OVER MgCl2/AlEtn(OEt)3-n SUPPORTEDHALF-TITANOCENE CATALYSTS
- Acta Polymerica Sinica Issue 12, Pages: 1129-1134(2008)
- 作者机构：
- 作者简介：
- 基金信息：
- DOI：10.3724/SP.J.1105.2008.01129
  CLC：
- Published：20 December 2008，
扫描看全文
LIU Dan, ZHU Fangming, LIN Shang’an. ETHYLENE POLYMERIZATION OVER MgCl2/AlEtn(OEt)3-n SUPPORTEDHALF-TITANOCENE CATALYSTS. [J]. Acta Polymerica Sinica (12):1129-1134(2008)
DOI：

LIU Dan, ZHU Fangming, LIN Shang’an. ETHYLENE POLYMERIZATION OVER MgCl2/AlEtn(OEt)3-n SUPPORTEDHALF-TITANOCENE CATALYSTS. [J]. Acta Polymerica Sinica (12):1129-1134(2008) DOI： 10.3724/SP.J.1105.2008.01129.

摘要

以MgCl2/AlEtn(OEt)3-n为载体，分别负载五甲基茂基三氯化钛（Cp*TiCl3）和五甲基茂基三苄氧基钛（Cp*Ti(OBz)3），得到两种负载催化剂，在较廉价的AlEt2Cl为助催化剂常压下可以高效地催化乙烯聚合.报道了载体的制备、聚合条件（不同的烷基铝助催化剂、聚合温度、铝钛摩尔比）对催化剂的聚合行为以及聚合物结构的影响.研究结果表明，两种负载催化体系对乙烯聚合具有较高的催化活性，可达105g PE/(mol Ti.h)数量级，所得聚乙烯的黏均分子量在105以上.经过13C-NMR 和 DSC分析，两种负载催化剂得到的均为线型聚乙烯.与均相催化剂相比，负载后的单茂钛催化体系的聚合反应动力学表现高效而平稳.这表明载体的微孔结构使活性中心得到了有效的分散，有效地提高了催化剂的活性，同时载体的受限空间有效抑制了聚乙烯增长链的β-H消除反应.

Abstract

Half-titanocene catalysts (CpTiCl3，CpTi(OBz)3) supported on MgCl2/AlEtn(OEt)3-n were used for ethylene polymerization with a cocatalyst of common inexpensive AlEt2Cl.The polymerization conditions such as the cocatalyst

Al/Ti ratio and temperature had significant effects on catalytic activity and properties of the resultant polyethylene.Results showed that the two supported catalysts exhibited high activity in the presence of AlEt2Cl with 105g PE/(mol Ti#8226;h) magnitude of order

and the viscometric molecular weight of the obtained polyethylene was higher than 105.In addition

the prepared polyethylene was essentially linear polyethylene according to 13C-NMR and DSC analyses.Compared with the corresponding homogeneous catalyst system

the kinetic curves of polymerization were quite steady during the reaction process.It is recommended that the surface morphology and the internal porous structure of the supported catalyst were beneficial for the dispersion of active species

resulting in the increase of the activity

and the active species anchored on confined space of MgCl2/AlEtn(OEt)3-n pores could inhibit the occurrence of β-H elimination reaction.

关键词

单茂钛催化剂载体催化剂聚乙烯配位聚合

Keywords

references

更多指标>

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

SYNTHESIS AND CHARACTERIZATION OF Zr CATALYST WITH PHENOL NITRONE LIGAND FOR ETHYLENE POLYMERIZATION

KINETIC STUDIES ON COORDINATION POLYMERIZATION OF BUTADIENE VIA REAL-TIME ART-FTIR MONITORING

STUDIES ON STRUCTURE EVOLUTION OF LDPE DURING CROSSLINKING PROCESS BY RHEOLOGICAL TESTS

PROGRESS OF NICKEL COMPLEXES AS CATALYSTS FOR ETHYLENE OLIGOMERIZATION/POLYMERIZATION

PREPARATION OF PE/CNTs SHISH-KEBAB STRUCTURES USING SOLUTION CRYSTALLIZATION

Related Author

No data

Related Institution

No data

Postal code：100190
Tel：010-62588927 Email：gfzxb@iccas.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备05002797号-8 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰