PREDICTION OF MISCIBILITY OF POLYIMIDES AND GASOLINE COMPONENTS BY MONTE CARLO SIMULATION

LU Fuwei; LV Hongling; KONG Ying; MA Cheng; ZHANG Hongyu; YANG Jinrong

doi:10.3724/SP.J.1105.2012.11193

您当前的位置：

首页 >

文章列表页 >

PREDICTION OF MISCIBILITY OF POLYIMIDES AND GASOLINE COMPONENTS BY MONTE CARLO SIMULATION

Research Article | 更新时间：2021-03-19

- PREDICTION OF MISCIBILITY OF POLYIMIDES AND GASOLINE COMPONENTS BY MONTE CARLO SIMULATION
- Acta Polymerica Sinica Issue 4, Pages: 374-378(2012)
- 作者机构：
  
  中国石油大学华东,重质油国家重点实验室,青岛,266555
- 作者简介：
- 基金信息：
- DOI：10.3724/SP.J.1105.2012.11193
  CLC：
- Published：20 April 2012，
扫描看全文
LU Fuwei, LV Hongling, KONG Ying, MA Cheng, ZHANG Hongyu, YANG Jinrong. PREDICTION OF MISCIBILITY OF POLYIMIDES AND GASOLINE COMPONENTS BY MONTE CARLO SIMULATION. [J]. Acta Polymerica Sinica (4):374-378(2012)
DOI：

LU Fuwei, LV Hongling, KONG Ying, MA Cheng, ZHANG Hongyu, YANG Jinrong. PREDICTION OF MISCIBILITY OF POLYIMIDES AND GASOLINE COMPONENTS BY MONTE CARLO SIMULATION. [J]. Acta Polymerica Sinica (4):374-378(2012) DOI： 10.3724/SP.J.1105.2012.11193.

摘要

利用Monte Carlo 模拟研究了不同结构的聚酰亚胺与典型汽油组分的相容性.结果表明

4'-二苯甲酮四羧酸二酐-2

6-三甲基对苯二胺(BTDA-3MPDA)与典型汽油组分的相容性较高

且对噻吩的选择性高于其他结构的聚酰亚胺.在300~500 K温度范围内

BTDA-3MPDA与五种典型汽油组分混合能均随着温度的升高而降低

但对噻吩的选择性下降.在350 K时

BTDA-3MPDA与噻吩的混合自由能低于其他烃类

因而可以选择性吸附汽油中噻吩

用于汽油脱硫过程.

Abstract

The miscibility behavior of polyimides (PI) of different structures and five gasoline components was studied by using Monte Carlo simulation method.The results indicated that the miscibility of 3

4'-benzophenonetetracarboxylic dianhydride-2

6-trimethyl-p-phenylenediamine (BTDA-3MPDA) and gasoline components was prior

and its selectivity of thiophene was better than that of the other PIs.In the temperature of range 300~500 K

the mixed energy between BTDA-3MPDA and gasoline components decreased with increase of temperature.However

the selectivity of thiophene decreased with the increasing temperature.The temperature of 350 K was selected for the further study of the miscibility of BTDA-3MPDA and gasoline components

while the mole free energy between BTDA-3MPDA and thiophene was much smaller than that for the other gasoline components.Thus

BTDA-3MPDA could be played as a selective material for gasoline desulfurization.

关键词

聚酰亚胺汽油脱硫Monte Carlo 模拟溶解性

Keywords

PolyimideGasoline desulfurizationMonte Carlo simulationSolubility

references

更多指标>

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Preparation and Properties of Composite Proton Exchange Membranes from Tröger's Base-based Polyimides/Polybenzimidazoles for Fuel Cells Operating in a Wide Temperature Range

Preparation and Performance of Thermally Rearranged Gas Separation Membranes Containing Tetraarylimidazole Structure

Preparation, Processing and Thermal Properties of Naphthaleneethynyl-terminated Silica-containing Polyimides

Preparation of Colorless Transparent Polyimide Films with High Comprehensive Properties

Preparation and Properties of Colorless Transparent Polyimide Films Based on Rigid Alicyclic Tetracarboxylic Anhydride

Related Author

No data

Related Institution

School of Chemical Engineering, University of Chinese Academy of Sciences

State Key Laboratory of Biochemical Engineering, Institute of Process Engineering, Chinese Academy of Sciences

Chemistry and Environmental Engineering, Yangtze University

Carbon Research Laboratory, State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology

School of Chemical Engineering, University of Science and Technology Liaoning

Postal code：100190
Tel：010-62588927 Email：gfzxb@iccas.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备05002797号-8 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰